IN-13 – surfncircuits

Tag: IN-13

2 Posts

Kook Hack, Nixie Tubes, python, Raspberry Pi Projects

Finishing the IN-9/IN-13 Nixie Tube Driver for the Raspberry Pi (Part 2)

October 6, 2019 — 2 Comments

Circuit Projects, Kook Hack, Nixie Tubes, python, Raspberry Pi Projects

Help Design A Linear Nixie Tube HAT for the Raspberry Pi (Part 1)

February 16, 2019 — 1 Comment

Mark Smith on KiCad Power Tools Help Shrink The Nixie Tube Power Supply (part 3)November 26, 2022
Hi Dan, Typically less than 170v can work to provide a stable strike. Although you can adjust the nixie supply…
Dan on KiCad Power Tools Help Shrink The Nixie Tube Power Supply (part 3)November 26, 2022
Hi Mark! I really love your work but got a simple question. Why is output voltage of your circuit is…
Mark Smith on An Analog 15 Minute Turn Off Timer for the BMW M3 E36 Trunk Light. (No 555 used here)October 31, 2022
Hi Don, I have seen the relief timer work for cabin lights , But this relief timer does not apply…
Don on An Analog 15 Minute Turn Off Timer for the BMW M3 E36 Trunk Light. (No 555 used here)October 31, 2022
Interesting, the E36 is already equiped with a 'relief relay' that cuts out power after 15 minutes.
robbi on Implementing a Single Edge Nibble Transmission (SENT) Protocol in Python for the Raspberry Pi ZeroOctober 22, 2022
any ideas to make this run in micropython? xD