surfncircuits

img_9242

Date: September 28, 2019Author: Mark Smith 0 Comments

Enter your email address to subscribe to this blog and receive notifications of new posts and project downloads by email.

Email Address

An Espresso Maker That Knows When You Want Some
Implementing a Single Edge Nibble Transmission (SENT) Protocol in Python for the Raspberry Pi Zero
Connecting to Vintage Tektronix TDS 700 series Oscilloscopes with Python and Ethernet
AC Current Limiter for Safer Electronic Repairs
Finishing the IN-9/IN-13 Nixie Tube Driver for the Raspberry Pi (Part 2)

Surfncircuits lab in purple

Steamboat Springs, Co 2021

San Luis Obispo, Ca 2021

Steamboat Springs, Co 2020

Repairing the E36 Glovebox Flashlight

3D Printed Case for Espresso Connect

Grand Teton National Park, 2019

Maldives Surf Day June 2019

Brianna Simmons on Surf Checker Provides Surf Spot Water TempsSeptember 29, 2021
Lovely blogg you have here
Mark Smith on An Espresso Maker That Knows When You Want SomeSeptember 10, 2021
I also thought about an ultrasonic sensor that would attach to the top water cover, but then it would have…
Kevin on An Espresso Maker That Knows When You Want SomeSeptember 10, 2021
Ryan, I tried an ultrasonic one but there was a problem with it - not good with really close distances…
Ryan on An Espresso Maker That Knows When You Want SomeSeptember 9, 2021
Did you use a floating target for the VL6180X? I tried ToF sensors for a sump pump controller project, and…
Kevin on An Espresso Maker That Knows When You Want SomeSeptember 9, 2021
A blog post about the sensor would be amazing! Thanks.